mlabel

Section: User Commands (1)
Updated: 29Aug09
Index Return to Main Contents
 

Name

mlabel - make an MSDOS volume label

 

Note of warning

This manpage has been automatically generated from mtools's texinfo documentation, and may not be entirely accurate or complete. See the end of this man page for details.

 

Description

The mlabel command adds a volume label to a disk. Its syntax is:

mlabel [-vcsn] [-N serial] drive:[new_label]

 

Mlabel displays the current volume label, if present. If new_label is not given, and if neither the c nor the s options are set, it prompts the user for a new volume label. To delete an existing volume label, press return at the prompt.

Reasonable care is taken to create a valid MS-DOS volume label. If an invalid label is specified, mlabel changes the label (and displays the new label if the verbose mode is set). Mlabel returns 0 on success or 1 on failure.

Mlabel supports the following options:

c 
Clears an existing label, without prompting the user
s 
Shows the existing label, without prompting the user.
 
Assigns a new (random) serial number to the disk
serial 
Sets the supplied serial number. The serial number should be supplied as an 8 digit hexadecimal number, without spaces

 

See Also

Mtools' texinfo doc  

Viewing the texi doc

This manpage has been automatically generated from mtools's texinfo documentation. However, this process is only approximative, and some items, such as crossreferences, footnotes and indices are lost in this translation process. Indeed, these items have no appropriate representation in the manpage format. Moreover, not all information has been translated into the manpage version. Thus I strongly advise you to use the original texinfo doc. See the end of this manpage for instructions how to view the texinfo doc.
*   
To generate a printable copy from the texinfo doc, run the following commands:
 
    ./configure; make dvi; dvips mtools.dvi

 
*   
To generate a html copy, run:
 
    ./configure; make html

  A premade html can be found at Infinityhttp://www.gnu.org/software/mtools/manual/mtools.htmlIntegral
*   
To generate an info copy (browsable using emacs' info mode), run:
 
    ./configure; make info

 

The texinfo doc looks most pretty when printed or as html. Indeed, in the info version certain examples are difficult to read due to the quoting conventions used in info.